Dynamixel modules and pieces
All accessories allowing you to power, command and attach Dynamixel servomotors to build mobile robots and robotics arms.
The DYD (DYNAMIXEL Drive) is a high-precision gear known for its exceptional impact resistance.
Supplier Reference: 902-0164-000
DYNAMIXEL TRAINING (DYD) is a high-precision gear with superior shock resistance.
Supplier Reference: 902-0165-000
Dynamixel Drive DYD for Dynamixel-P servomotor is a high-precision Robotis gear that is ideal for its superior impact resistance.
The DYD-15-051 high-precision gear is a cycloid-based reducer designed to offer optimum strength and robustness throughout its 5,000 hours of use.
Use the proper bolts for fixing your Dynamixel servos!
FP04-F12 frame for Bioloid kit. Compatible only with the AX-series Dynamixel servomotors. Bolts an nuts are not included (see the accessories section).
FP04-F11 frame for Bioloid kit. Compatible only with the AX-series Dynamixel servomotors. Bolts an nuts are not included (see the accessories section).
Make sure you choose tools truly compatible with your M2 and S1 screws and for fixing the servo horns and bearings on your servo motors with this Pack of 400 M2 nuts for Dynamixel AX-series servo motors!
A set of 50 Bolt PHS M2x10 screws for mounting your Dynamixel servomotors.
Add this 50 pieces S2 PHS Bolt M2*8 kit for Dynamixel servomotors to your roboticists’ toolbox.
Have you ever been afraid of running out of assembly parts in the middle of a project? With this set of 400 S1 Bolt PHS M2x6 for Dynamixel Servomotors , you’ll have more than enough bolts to keep going for a while !
use this PCB connector to extend your constructions based on Dynamixel actuators
The FP04-F8 frames from Robotis are designed to adapt perfectly to the Dynamixel AX-series servo motors.
FP04-F12 frame for Bioloid kit. Compatible only with the AX-series Dynamixel servomotors. Bolts an nuts are not included (see the accessories section). This part can be used as a wheel when connected to a AX-12A servomotor.
Make your OpenCM9.04-A control board for Dynamixel servomotors complete with this accessory set.
FP04-F18 frame for Bioloid kit. Compatible only with the AX-series Dynamixel servomotors. Bolts an nuts are not included (see the accessories section).
This set of 5 FP04-F9 side mounting frames is designed for the Bioloid robotics kits by Robotis.
Make sure you choose tools truly compatible with your M2.5 screws and for fixing the servo horns and bearings on your servo motors with this Pack of 400 M2.5 nuts for Dynamixel RX-series servo motors!
The BNS-30 bolt/nut set for Dynamixel AX-series servos includes 70 tapping screws and can be used as an add-on to your BNS-10 set.
Robotis put together this pack of 20 FP04-F55 Dynamixel Cable Holders to more efficiently organise Bioloid robot cables.
The Trossen Robotics 350 mm 3-pin cable is a go-to Dynamixel actuator project accessory.
These 4 x 120 mm 4P cables (for wireless module) are intended exclusively for connecting your Dynamixel servo motors using the RS485 protocol.