Dynamixel modules and pieces
All accessories allowing you to power, command and attach Dynamixel servomotors to build mobile robots and robotics arms.
The USB2AX is a small interface to control Dynamixel servomotors like the AX-12 or the MX-28T from a computer.
Program many Dynamixel servos directly with the U2D2 Dynamixel/PC connector, for AX/MX to pro series!
The SMPS2Dynamixel allows you to power your Dynamixel servomotors if you don't use a controller.
Horn and bearing set for Dynamixel actuators compatible with the RX-24F, RX-28 and MX-28 actuators.
use this PCB connector to extend your constructions based on Dynamixel actuators
10 cables (20cm length) with 3 pin connectors for the Dynamixel servomotors of the AX and MX-xxT series.
The Dynamixel shield for Arduino from Robotis can be used to control yourDynamixel servo motors using your Arduino board or an OpenCR controller.
Horn for Dynamixel actuators RX-64 (N101 Type) ,EX-106+, MX-64 and MX-106
The PS-10 SMPS charger allows you to power your Dynamixel controllers and servomotors.
The HN11-I101 Horn Set is the perfect fit for Dynamixel XL430 servos.
You can now power, connect and program all your Dynamixel servos, whatever the model, thanks to this official and very clever Dynamixel starter set.
The U2D2 board from Robotis enables you to supply a variety of power sources to your Dynamixel servo motors.
Horn and Bearing set for Dynamixel compatible with RX-24F and RX-28 actuators.
Horn and bearing set compatible with RX-64 (N101 type), EX-106+, MX-64 and MX-106 Dynamixel actuators.
This set of 10 FP04-F3 side mounting frames is designed for the Bioloid robotics kits by Robotis that use the AX series Dynamixel servomotors.
Choose quality cables for powering your Dynamixel XL servos tailored to your projects’ needs by opting for this pack of five 3P 160 mm Cables for XL Servos.
The OpenCM 485 Expansion Board connects to your OpenCM9.04 Controller so you can benefit from additional Dynamixel ports.
The BNS-10 Nut and Bolt Set is a kit that will allow you to not only assemble Dynamixel AX (12+) servo motors, but also fit your mobile robot with an AX-S1 sensor and CM-5 or CM-510 controller.
In this set, you’ll find 10 sturdy plastic structural components for Dynamixel AX servo motors, suitable for replacing components in Bioloid robots.
The HN12-I101 Horn Set is the perfect fit for Dynamixel X-series 430 servos.
10 cables (18cm lenght) with 3 pin connectors for the Dynamixel servomotors of the AX and MX-xxT series.
This 3P Cable Set for Dynamixel servo motors in the AX and MX series lets you make all the standard connections between your robot and the various sensors and actuators that it needs.
HN12-N101 is the ideal horn set for making the most of the new Dynamixel X-series 430 smart servos. It’s study and a perfect fit!