Gadgeteer modules

The TempHumid SI70 is a module you can connect to your Gadgeteer board to integrate a temperature and humidity sensor into your project.

If you’ve always wanted to open your Raspberry Pi up to the world of .NET Gadgeteer, it’s high time you got your hands on this appropriately-named little FEZ Utility add-on!

Standoff pack to attach your Gadgeteer boards.

This MEMS based gyro sensor will allow you to measure the angular rate of your mobile contraptions of three axis !

Rather than using a long cable, use this Extender Module that can connect two Gadgeteer cables. This module also exposes the connections needed for analysing the signal or to be connected to a breadboard.

Gadgeteer module that allows you to connect your .NET Gadgeteer circuits to a CAN bus data.

A circular 7 led matrix that you can control accurately (rotate, blink, alternate,...). Very useful to communicate debug information of events in your programs.

Any good circuit uses a potentiometer, right? Well here's one for your Gadgeteer circuits !

This Gadgeteer module features a smart multicolor LED. This LED is programmable and the module can be chained with other similar modules using the DaisyLink protocol.

10 pin SMD Gadgeteer Socket. It is the same one used on all .NET Gadgeteer modules and mainboards. use it to make your own prototypes and extansions.

Gadgeteer module to plug a Xbee chip

MicroSD HC flash memory with a capacity of 4GB. Allow you to do advanced datalogging and to store large files.

This Gadgeteer module will allow you to easily interface with most CNC controller boards

This Gadgeteer module is very useful for controllin high current charges. Supports up to 3A/50V.

Build and control your very own Gadgeteer based robot thanks to this powerful and reliable motor driver

This Gadgeteer module will allow you reading standard 125Khz RFID tags.

This Gadgeteer module is capable of converting any UART link into a standard RS232 interface. Old School Fashion !

Add memory to your Gadgeteer project using this module that accept an SD memory card !

Connect USB keys, mouses and keyboards using ths Gadgeteer module.

This Gadgeteer module will allow you displaying videos on monitors and TVs.

Pack of 10 .NET Gadgeteer compatible cables with a length of 10cm

16x2 character display module with controllable blue back-light.

Your Gadgeteer contraption will be able to sense an electric current in a Non-Invasive way

Ethernet Gadgeteer Module to connect your electronic creation using an Ethernet cable.