.

Câbles

Different cables for your robots or others needs.

Câbles

Filter By

Active filters

This 5V USB to 9V jack power cable ideal for your Marty robot, but it can be used anywhere a 9V source is needed.

In Stock

Make sure you always have your favourite cables to hand when prototyping! This hook-up wire spool set of 22 AWG cables in various colours will save you the hassle of looking everywhere for your breadboard cables – they’re all there, stored neatly away, just waiting to be used!

In Stock

Simple six wire cable with a 10cm length. Great for jumping from board to board or just about anything else. There is a 6-pin JST RE connector on both ends. These are simple jumper wires used on standard 0.1" breakaway headers.

In Stock

This long, thin USB cable with its mini-USB Type-A connector allows you to connect small USB devices equipped with a mini-B port.

Cannot be used for data transfer, only for power supply.
In Stock

3 pin Extension cable for servomotors, ultrasound sonar sensor Ping))), LCD screen and all 3 pin sensors. The lenght of the cable is 10 cm (4-inch).

In Stock

USB Type-A to mini B cable: the most practical for lightweight devices

In Stock

3 pin Extension cable for servomotors, ultrasound sonar sensor Ping))), LCD screen and all 3 pin sensors. The lenght of the cable is 20 cm (8-inch).

In Stock

USB 2 Cable with a length of 1.80 m, A-B type

In Stock

This USB 2.0 cable allows you to connect your Micro-B port devices to a USB Type A port to download data or power the device via USB.

In Stock

This pack of thirty 3-wire extension cables by Parallax will prove extremely useful when wiring your projects, however big or complex!

In Stock

This USB-A to Micro-B Cable provides a high quality connection between Micro USB-equipped USB 2.0 devices (smartphones, Raspberry Pi, tablets, etc) and computers.

In Stock

3 pin Extension cable for servomotors, ultrasound sonar sensor Ping))), LCD screen and all 3 pin sensors. The lenght of the cable is 30 cm (12-inch).

In Stock

USB cable A-microB

In Stock

4.5 m of 10-wire ribbon cable for neat connections!

In Stock

A USB TTL serial cable for connecting your Raspberry Pi to your computer. 4 cables + 1 USB port = simple and effective!

In Stock

Create a nice and tidy wire harness for your multiple connections with this 4.5 m 6-wire ribbon cable.

In Stock

USB cable used for PC programming of a microcontroller with a USB mini-B port.

In Stock

Are you looking for the best way to reconcile your Raspberry Pi or Beagle Bone with the Grove system? This Grove 4-pin/4-pin jumper conversion cable will increase your wiring possibilities.

In Stock

This pack of 50 jumper male-male is a good start to get your prototyping starting!

In Stock

This 20 jumper wires harness is great for prototyping neatly! If you want, you can also pull the ribbon wires off to make individual jumpers.

In Stock

This set of 10 30 cm long 3-pin cables is for use with sensors, servomotors and other RobotGeek modules.

In Stock

Make neatly organised circuits with these female/female 30-cm long jumper wires in various colours!

In Stock

A set of 40 female-female cables of different colors for standard 0.1" (2.54mm) headers.

In Stock

This 40 jumper wires harness will be quite handy for prototyping.You also have the possibility to pull the ribbon wires off to make individual jumpers.

In Stock