Câbles

Different types of cables for your robots or other projects. You will find here USB cables (all types), as well as cables for prototyping (jumper, Dupont...).

Active filters

This 5V USB to 9V jack power cable ideal for your Marty robot, but it can be used anywhere a 9V source is needed.

In Stock

Make sure you always have your favourite cables to hand when prototyping! This hook-up wire spool set of 22 AWG cables in various colours will save you the hassle of looking everywhere for your breadboard cables – they’re all there, stored neatly away, just waiting to be used!

In Stock

USB Type-A to mini B cable: the most practical for lightweight devices

In Stock

Simple six wire cable with a 10cm length. Great for jumping from board to board or just about anything else. There is a 6-pin JST RE connector on both ends. These are simple jumper wires used on standard 0.1" breakaway headers.

In Stock

USB 2 Cable with a length of 1.80 m, A-B type

In Stock

3 pin Extension cable for servomotors, ultrasound sonar sensor Ping))), LCD screen and all 3 pin sensors. The lenght of the cable is 10 cm (4-inch).

In Stock

USB cable A-microB

Out-of-Stock

3 pin Extension cable for servomotors, ultrasound sonar sensor Ping))), LCD screen and all 3 pin sensors. The lenght of the cable is 20 cm (8-inch).

In Stock

USB cable used for PC programming of a microcontroller with a USB mini-B port.

In Stock

This pack of thirty 3-wire extension cables by Parallax will prove extremely useful when wiring your projects, however big or complex!

In Stock

A USB TTL serial cable for connecting your Raspberry Pi to your computer. 4 cables + 1 USB port = simple and effective!

In Stock

3 pin Extension cable for servomotors, ultrasound sonar sensor Ping))), LCD screen and all 3 pin sensors. The lenght of the cable is 25,4 cm (10-inch).

A dedicated USB cable/jack to connect your Odroid boards to a USB host.

In Stock

3 pin Extension cable for servomotors, ultrasound sonar sensor Ping))), LCD screen and all 3 pin sensors. The lenght of the cable is 30 cm (12-inch).

In Stock

4.5 m of 10-wire ribbon cable for neat connections!

In Stock
€14.85 €16.50 -10%

Connect up to four USB devices thanks to this compact USB hub and benefit from an incomparable data exchange rate thanks to the USB 3.0 communication protocol!

In Stock
€2.66 €2.95 -10%

Create a nice and tidy wire harness for your multiple connections with this 4.5 m 6-wire ribbon cable.

In Stock

Are you looking for the best way to reconcile your Raspberry Pi or Beagle Bone with the Grove system? This Grove 4-pin/4-pin jumper conversion cable will increase your wiring possibilities.

In Stock

This pack of 50 jumper male-male is a good start to get your prototyping starting!

In Stock

This 20 jumper wires harness is great for prototyping neatly! If you want, you can also pull the ribbon wires off to make individual jumpers.

In Stock

This set of 10 30 cm long 3-pin cables is for use with sensors, servomotors and other RobotGeek modules.

In Stock

Make neatly organised circuits with these female/female 30-cm long jumper wires in various colours!

In Stock

A set of 40 female-female cables of different colors for standard 0.1" (2.54mm) headers.

In Stock

This 40 jumper wires harness will be quite handy for prototyping.You also have the possibility to pull the ribbon wires off to make individual jumpers.

In Stock