Peewee Runt Rover™ robotics chassis

Runt Rover™: a complete range of robotics kits for learning all about robots

The Peewee chassis comes from a very large family! The Runt Rover™ robots all share the same objective: to make learning robotics easier thanks to ultra-simple kits that are both easily assembled (without any tools) and compatible with a wide range of microcontrollers thanks to multi-board electronic mounts that adapt to different formats. This means you can use an Arduino robotics chassis, a SparkFun RedBoard robotics chassis or a Raspberry Pi version of your Peewee Runt Rover™ chassis. You can also install other modules, including a motor or motion controller, and the external chassis can accommodate additional components.

Embark on the Peewee Big Adventure

Peewee is a small chassis for a 2WD robot, i.e. a chassis with two drive wheels each equipped with a 140 rpm motor, and with ABS plastic plates that snap together to create a small all-terrain vehicle. In short, a robotics chassis that can be customised at will and at little expense with Actobotics parts or other components of your choice.

Technical specifications of the Peewee Runt Rover™ educational robot

The kit includes:

• 2 x 64.7 mm wheels
• 2 x 140 pre-wired motors
• 1 bottom chassis plate
• 1 top chassis plate
• 2 side chassis plates
• 2 electronics snap-mounts
• 2 stabiliser plates
• Required (not supplied):
• 1 AA battery tray
• 4 AA batteries
• Motor specifications:
• Recommended voltage: 4.5 Vdc
• No-load speed: 140 rpm
• No-load current: 190 mA
• Max. load current: 250 mA
• Torque: 800 gf-cm
• Total weight: 490 g

Resources for the Peewee Runt Rover™

Examine your Peewee Runt Rover™ from every angle with this video showing you how to assemble the kit and a 3D view.

• Peewee Runt Rover™ 3D view