LEGO Education - Learning system for all students
A division of the famous LEGO® group, LEGO® Education solutions was released on the market 30 years ago. A user-friendly learning system, LEGO® Education offers a practical and fun approach based on creativity, communication and collaboration. Suitable to all students, it stimulates the imagination and uses physical and digital designs to develop new skills. Appreciated by teachers and students alike, LEGO® Education offers a comprehensive range of products, such as Lego Spike, which allows students to become familiar with robotics. Getting started with the LEGO® ecosystem is easy and it is not necessary to buy any additional tools, such as soldering sets or screwdrivers.
LEGO® Education has been developed into three sets, suitable to any school level:
- LEGO WeDo=> Primary school
- Spike => Middle school
- Mindstorms EV3 => High school / university
Spike Prime is a colourful STEAM educational kit, created by LEGO, that allows progressive learning of programming, robotics, and scientific disciplines – combined with just the right amount of fun to keep children captivated!
“A Raspberry Pi Brain for your LEGO robot”, a few words summing up to perfection the extremely tempting offer made by the PiStorms Starter Kit, the key attraction of which is none other than the PiStorms controller. It fits like a shield over your Raspberry Pi to give your EV3 or NXT robot a whole load of brand-new functions!
The Arduino EVShield for EV3 is the easiest and most effective way of making your Lego EV3 or NXT creation even more interactive.
Add all the Grove sensors you want to your NXT or EV3 robot with this Mindsensors Grove Sensor Adapter.
Connect up to three solar panel to your NXT robot using this component.
This LEGO Spike Prime Expansion Kit allows you to expand on the experiments conducted using the basic robotics kit. Even more hours of STEAM learning and fun!
Here is the rechargeable battery Pack for your EVShield (Arduino + Lego Mindstorms EV3).
With the Camera Mount for PiStorms you can fix a camera to your PiStorms kit (Base Kit or Starter Kit) in the blink of an eye.
The EV3 Sensor Multiplexer is the best way of equipping your EV3 or NXT robot with new accessories when you don’t have enough available ports on your Lego brick.
This colour display module can be used with an Arduino board, with or without an EVShield.
Perpetual License
This ISP cable allows to reprogram the firmware of the BrickPi. This cable is only necessary if you decide to load a modified firmware on the BrickPi.
NXTServo-v3 is a 8 channel ESC Servo controller module
Here is the rechargeable battery Pack for your PiStorms (Raspberry Pi + Lego Mindstorms EV3).
The Linear Actuator 100 mm for NXT or EV3 is designed to equip Lego EV3 robots and enable them to push or pull a load over a distance of 100 mm.
Robot Virtual Worlds 4.0 for Lego Minstorms - 1 user perpetual license
Oscilloscope to measure low level signals on your electronic circuits.
The BrickP3 is an interface between Rasperry Pi and the Lego Mindstorms ecosystem. The base kit contains the BrickPi board, a protection case, a battery pack and its charger.
Robot Virtual Worlds 4.0 for Lego Minstorms - 6 user perpetual license
This Port Splitter allows you to split a NXT port and connect upto 3 I2C compliant sensors or Lego servo motors to single NXT Port.
Range of 8 ight sensors embeded into one single sensor for a very efficient line following robot