.

Raspberry Pi and Arduino for Lego Mindstorms

Upgrade your Lego Mindstorms creations with the inclusion of a Raspberry Pi board or an Arduino board! It is possible to replace the EV3 or NXT intelligent bricks with one of these two components, allowing you to build powerful robots and to use the broad of sensors available for these platforms.

Active filters

The Arduino EVShield for EV3 is the easiest and most effective way of making your Lego EV3 or NXT creation even more interactive.

In Stock

“A Raspberry Pi Brain for your LEGO robot”, a few words summing up to perfection the extremely tempting offer made by the PiStorms Starter Kit, the key attraction of which is none other than the PiStorms controller. It fits like a shield over your Raspberry Pi to give your EV3 or NXT robot a whole load of brand-new functions!

In Stock

With the Camera Mount for PiStorms you can fix a camera to your PiStorms kit (Base Kit or Starter Kit) in the blink of an eye.

In Stock

Here is the rechargeable battery Pack for your EVShield (Arduino + Lego Mindstorms EV3).

In Stock

This ISP cable allows to reprogram the firmware of the BrickPi. This cable is only necessary if you decide to load a modified firmware on the BrickPi.

In Stock

This colour display module can be used with an Arduino board, with or without an EVShield.

In Stock

Here is the rechargeable battery Pack for your PiStorms (Raspberry Pi + Lego Mindstorms EV3).

In Stock
€118.80

The BrickPi3 is an interface between Rasperry Pi and the Lego Mindstorms ecosystem. The base kit contains the BrickPi3 board, a protection case, a battery pack and its power cable.

In Stock

Everything you need to start with the BrickPi3 ! This kit comes with the Raspberry Pi 3 B+board (WiFi + Bluetooth).

Product available for orders