Ball bearings
Ball bearing is a mechanical component that optimizes the rotation of an axis by limiting or avoiding friction and jolts. It allows to gain speed and traction power.
The ServoCity Ball Bearing Idler Shaft integrates easily into projects with timing belts.
These 12 mm linear ball bearings enable a very smooth motion along rails.
Powered by either a drive mechanism, inertia or by hand, these 8 mm linear ball bearings are perfect for projects requiring a low friction slide mechanism.
The ServoCity 3/8″ Bearing with Two Fixation Points is a very robust robotics component capable of supporting heavy loads.
With the ServoCity 5/8″ Bearing with Two Fixation Points, your robotics chassis kit will benefit from a solid, lightweight, well-designed component.
In the broad family of ServoCity robotic components, meet the ServoCity 1″ Bearing with Two Fixation Points, lightweight yet very efficient.
For an efficient and robust ServoCity bearing, four fixation points are better than two!
The ServoCity 5/8″ Bearing with Four Side Fixation Points is the perfect solution for your rotary axes measuring 15.8 mm in diameter.
The 1/2″ Bearing with Four Thru-Hole Fixation Points (Wide) is a bearing with a wider structure for better meeting your needs.
How will you use this 5/8″ Bearing with Four Thru-Hole Fixation Points? One thing’s for sure, the possibilities are endless!
A high-quality ServoCity ball bearing for all kinds of projects.
This set of two 3/16” x 3/8” ball bearings can be used in many projects, including outdoor mobile robots.
Your robotics chassis kit would not be complete without its 5/16” x 1/2” Ball Bearing!
This set of two 1/2” x 1.1/8” ball bearings can be easily integrated into all your robotics chassis projects requiring a high-quality rotation.
This stainless steel 1” x 2” Ball Bearing us designed for use with a variety of mounting options on axes measuring 25.4 mm (1”) in diameter.
Made of stainless steel, this 1” x 1.245” Ball Bearing will perfectly fit your axes measuring 25.4 mm (1”) in diameter.
Design your best mobile robotics chassis with the 4 x 12 mm Ball Bearing.
In the wide range of bearings available on your website, check out this set of two 1/8” x 1/4” Non-Flanged Ball Bearings in stainless steel.
This set of 2 ServoCity 3/16” x 5/16” Non-Flanged Ball Bearings made of stainless steel is designed for use with a rotary shaft of 4.76 mm (3/16”) in diameter.
A ServoCity ball bearing of 4.76 mm in diameter for your robotics chassis kit.
Our range of stainless steel bearings has grown once again with the addition of this pack of two 1/4” x 1/2” rimless ball bearings!
These ServoCity 5/16” x 1/2” Non-Flanged Ball Bearings allows for a smooth rotation of your robotics chassis kit with a shaft.