.

Tools and materials

Soldering kits, tools for electronics, breadboards and wire jumpers, 3D printers, measuring instruments, logic analysers and even thermoplastic polymer... the essential equipment for any robotician is here!

Active filters

This is a 8-pin female header, with extra long legs is the ideal product for stacking Arduino shields.

In Stock

This 6-Pin Stackable Header for Arduino will allow you to easily connect your compatible shields on an Arduino base.

In Stock

The Qwiic JST connector - SMD 4-pin adapts to all Qwiic cables and allows you to customise your DIY I2C modules.

In Stock

This accessory stand from Seeed Studio was made for the Mini Soldering Iron. Both are cleverly designed and practical to carry around!

In Stock

This is a 6-pin female JST SH-type connector that works with magnetic encoders.

In Stock

This pack of 2 long 10 pin stacking header for Arduino is the ideal product to add shields to your Arduino. By using several of these connectors you can easily add multiple shields to your Arduino board.

In Stock

Connect your Qwiic modules as you see fit with the 50 mm Qwiic cable.

In Stock

Simple six wire cable with a 10cm length. Great for jumping from board to board or just about anything else. There is a 6-pin JST RE connector on both ends. These are simple jumper wires used on standard 0.1" breakaway headers.

In Stock

This pair of 12-pin and 16-pin stackable headers makes it possible to plug your Adafruit Feather board into a breadboard or to attach other compatible modules, without soldering.

In Stock

This six wire cable will allow you to connect boards together, or other components. They are compatible with the connectors listed below (see schematics). They have bare wires on one end and a 6-pin JST SH connector on the other end.

In Stock

Make your prototyping faster and more reliable!

In Stock

Connect your Qwiic components in the blink of an eye with the 200 mm Qwiic cable.

In Stock

This 100mm long 4-conductor cable with 1mm JST termination is designed to connect Qwiic enabled components together. It can also be used for other applications.

In Stock

These headers will allow you to stack several shields on top of your Arduino R3, Leonardo and new Arduino boards going forward.

In Stock

This headers are especially adapted to stack Arduino shields one on another so you can get maximal benefit from the Arduino technology.

In Stock

Stack multiple boards to your Raspberry Pi using this extra lonf stacking header.

In Stock

This long, thin USB cable with its mini-USB Type-A connector allows you to connect small USB devices equipped with a mini-B port.

Cannot be used for data transfer, only for power supply.
In Stock

USB 2 Cable with a length of 1.80 m, A-B type

In Stock

This 20 jumper wires harness is great for prototyping neatly! If you want, you can also pull the ribbon wires off to make individual jumpers.

In Stock

This 500 mm long 4-conductor cable with 1mm JST termination is designed to connect Qwiic enabled components together. It can also be used for other applications.

In Stock

Create a nice and tidy wire harness for your multiple connections with this 4.5 m 6-wire ribbon cable.

In Stock

USB Type-A to mini B cable: the most practical for lightweight devices

In Stock

The black modular Mini-Breadboard is a solderless breadboard ideal for building simple circuits. And for more ambitious projects, it can be combined with other boards to offer you more space!

In Stock

The white Modular Mini-Breadboard is a solderless breadboard ideal for building simple circuits. And for more ambitious projects, it can be combined with other boards to offer you more space!

In Stock