.
Tools and materials
Soldering kits, tools for electronics, breadboards and wire jumpers, 3D printers, measuring instruments, logic analysers and even thermoplastic polymer... the essential equipment for any robotician is here!
This kit is designed to connect NXT or EV3 to a breadboard.
This headers are especially adapted to stack Arduino shields one on another so you can get maximal benefit from the Arduino technology.
Set of colored jumper cables with stiff ends molted on for breadboards.
The 830-Point Breadboard offers all the space and tie points you need for small and medium-sized prototypes.
This 6-Pin Stackable Header for Arduino will allow you to easily connect your compatible shields on an Arduino base.
A set of 40 female-female cables of different colors for standard 0.1" (2.54mm) headers.
The white Modular Mini-Breadboard is a solderless breadboard ideal for building simple circuits. And for more ambitious projects, it can be combined with other boards to offer you more space!
In need of a truly precise temperature sensor? Check out the high precision I2C Temperature Sensor MCP9808 and its breakout board, you won’t be disappointed!
Stack multiple boards to your Raspberry Pi using this extra lonf stacking header.
This pack of 2 long 10 pin stacking header for Arduino is the ideal product to add shields to your Arduino. By using several of these connectors you can easily add multiple shields to your Arduino board.
The Bare Conductive electric paint offers many creation possibilities to artists, designers, researchers or electronics enthusiasts: you just need a brush and some water to invent new circuits and electronic components!
Put a stop to dull, muddy brown creations! Give your 3D prints a cheerful look with these bright 1.75 mm Chromatik PLA filaments!
These headers will allow you to stack several shields on top of your Arduino R3, Leonardo and new Arduino boards going forward.
Simple six wire cable with a 10cm length. Great for jumping from board to board or just about anything else. There is a 6-pin JST RE connector on both ends. These are simple jumper wires used on standard 0.1" breakaway headers.
This is a 8-pin female header, with extra long legs is the ideal product for stacking Arduino shields.
These headers with the standard steps of 0.1" (2.54mm) allow you to connect different PCB or components, to access debug pins or to use breadboards.
With the Touch Board Starter Kit, take your first steps in a fully interactive world of your imagination and creation!
This pack of 10 a multicoloured alligator clips is likely to be the most useful thing on your workbench!
The Bare Conductive electric paint (10 ml tube) opens up a whole new range of possibilities for creating electric circuits. Let go of your soldering iron and grab your brush!
A bright red colour that turns pale pink when the temperature rises: the COM-11555 Red Thermochromatic Pigment is a truly magical powder that will inject a bit of fun into your creations.
This six wire cable will allow you to connect boards together, or other components. They are compatible with the connectors listed below (see schematics). They have bare wires on one end and a 6-pin JST SH connector on the other end.
This 20 jumper wires harness is great for prototyping neatly! If you want, you can also pull the ribbon wires off to make individual jumpers.
The Grove Heart Rate Sensor is an extremely useful device for monitoring performance and physiological data for sportsmen and women and athletes.