.
Adapters and converters
Discover our series of adapters and converters to facilitate communication of the various modules in your robotics project
This USB to serial adapter will enable communication between your computer and your microcontroller.
Programmer for microcontrollers based on AVR technology. This programmer has been specificaly designed to program 3pi and m3pi robots from Pololu.
The WRL-11713 WiFi Dongle is the most efficient solution for equipping your pcDuino with a WiFi connection. And, even better, it also works with Raspberry Pi and BeagleBone Black!
This mini-USB to serial FTDI module can be installed on your 3.3V Arduino boards without a USB connector and will equip your Arduino with the very clever auto-reset function!
Check out the new Bluetooth breakout board by SparkFun, specially designed for Bluetooth Low Energy 4.0. Compatible with Arduino and Arduino Pro, the board is equipped with the BC118 Bluetooth BLE 4.0 module.
Simply connect a CAN to your microcontroller and enjoy the extreme precision of the ADS1115 16-Bit ADC for all your conversions!
This analog to digital converter is commanded in I2C and allows you to convert up to 4 independant analog inputs or two differential inputs. A programmable amplification up to x16 can be applied to the result.
This digital to analog converter receives a values from your microcontroller in I2C and transforms it into a corresponding analog voltage. This is very useful for audio or analog projects.
If you want to establish a communication between your computer’s USB port and your Arduino board, transmit data between these two components and even upload code, the USB-to-UART 5V/3V3 Adapter is just what you need!
FTDI basic board that is a USB/Serial converter
The RS-485 Breakout Board is equipped with a SP3485 RS-485 transceiver and a filter capacitor for rapidly transmitting your UART data.
Want to control and optimise your data rate without using UART? Get the CC3000 WiFi module and its dedicated WiFi Breakout Board and you can integrate the Internet into your projects!
This USB Audio Adapter, built around the CM108AH chipset, is equipped with 2 jacks and will adapt to all projects on ODROID.
The Makeblock-Me USB Host v1 allows you to easily connect your Makeblock board to a USB device.
Use this Me RJ25 Adapter Module to increase the connection possibilities of your Makeblock Me base board.
The EM-406 Connector Breakout allows you to connect the wires of compatible GPS modules to easily develop your microcontroller.
The Qwiic Adapter provides the perfect means to make any I2C board into a Qwiic-enabled board.