Câbles Dynamixel
Thanks to these cables, you will be able to set up the necessary wiring on your Dynamixel creations: connect your robots to the different sensors and actuators, as well as their control board. The Dynamixel cables are solid and long-lasting, a must-have in your toolbox!
Robotis put together this pack of 20 FP04-F55 Dynamixel Cable Holders to more efficiently organise Bioloid robot cables.
The Trossen Robotics 350 mm 3-pin cable is a go-to Dynamixel actuator project accessory.
These 4 x 120 mm 4P cables (for wireless module) are intended exclusively for connecting your Dynamixel servo motors using the RS485 protocol.
35cm long cable for Dynamixel X-series servo motors, TTL protocol.
This heavy duty 3-pin ribbon cable is compatible with the Dynamixel AX and MX actuators.
Use this pack of five 3P-Sync 160 mm cables for connecting two Dynamixel MX-106 and X540 servos in master/slave mode.
This set of four 150 mm 2P Cables (Gearmotor) is a reliable means of connecting your gearmotor to its battery housing.
This 150 mm 2P Cable (Battery Box) (x 4) set by Robotis allows you to establish a secure connection between your servo motors and their battery housing.
5 cables (15cm length) For 3P-5P conversion
Dynamixel X-series compatible cable (TTL), length 50 cm.
10 cables (6cm lenght) with 3 pin connectors for the Dynamixel servomotors of the AX and MX-xxT series.
10 cables (10cm lenght) with 3 pin connectors for the Dynamixel servomotors of the AX and MX-xxT series.
This pack of four 5P cables (150 mm) from Robotis makes it easy to connect your robot sensors.
4 cables (400m length) with 5 pin connectors for some Dynamixel servomotors, sensors and controllers (CM-100, CM-150, CM-530, CM-700).
10 cables (6cm lenght) with 4 pin connectors for the Dynamixel servomotors of the DX, RX and EX series.
10 cables (14cm lenght) with 3 pin connectors for the Dynamixel servomotors of the AX and MX-xxT series.
This pack of five 3P 110 mm Cables for XL Servos has been specially designed for connecting your Dynamixel servos to compatible controllers.
Choose quality cables for powering your Dynamixel XL servos tailored to your projects’ needs by opting for this pack of five 3P 130 mm Cables for XL Servos.
10 cables (18cm lenght) with 3 pin connectors for the Dynamixel servomotors of the AX and MX-xxT series.
10 cables (10cm length) with 4 pin connectors for the Dynamixel actuators of the MX (R version), RX and EX series.
10 cables (20cm length) with 3 pin connectors for the Dynamixel servomotors of the AX and MX-xxT series.
Choose quality cables for powering your Dynamixel XL servos tailored to your projects’ needs by opting for this pack of five 3P 160 mm Cables for XL Servos.
10 cables (14cm lenght) with 4 pin connectors for the Dynamixel servomotors of the DX, RX and EX series.
This pack of ten 180 mm X4P cables (convertible) is to be used with Dynamixel X-series servo motors with an RS485 interface.