This cable for SICK laser range finders has a 12-pin female connector for quickly connecting your installation.
This pack of four 5P cables (150 mm) from Robotis makes it easy to connect your robot sensors.
Use the proper bolts for fixing your Dynamixel servos!
This set of four 150 mm 2P Cables (Gearmotor) is a reliable means of connecting your gearmotor to its battery housing.
This 150 mm 2P Cable (Battery Box) (x 4) set by Robotis allows you to establish a secure connection between your servo motors and their battery housing.
Good news for all Raspberry Pi enthusiasts: the Raspberry Pi Zero WH board offers all the features of a Pi Zero, plus an already soldered GPIO 40-pin header!
Check out this YDLIDAR G4 360° laser range finder: an ultra-reduced model offering an amazing performance!
4 cables (400m length) with 5 pin connectors for some Dynamixel servomotors, sensors and controllers (CM-100, CM-150, CM-530, CM-700).
Available exclusively at Génération Robots, the Pixl board was made for using Dynamixel XL-320 motors on a Raspberry Pi designed for the Poppy Ergo Jr educational robot. Not compatible with Raspberry Pi 3B+.
Add this 50 pieces S2 PHS Bolt M2*8 kit for Dynamixel servomotors to your roboticists’ toolbox.
Make sure you choose tools truly compatible with your M2 and S1 screws and for fixing the servo horns and bearings on your servo motors with this Pack of 400 M2 nuts for Dynamixel AX-series servo motors!
This pack of five 3P 110 mm Cables for XL Servos has been specially designed for connecting your Dynamixel servos to compatible controllers.
Have you ever been afraid of running out of assembly parts in the middle of a project? With this set of 400 S1 Bolt PHS M2x6 for Dynamixel Servomotors , you’ll have more than enough bolts to keep going for a while !
Operating with five intelligent Dynamixel servomotors, the WidowX robot arm offers some great opportunity.
This 3P Cable Set for Dynamixel servo motors in the AX and MX series lets you make all the standard connections between your robot and the various sensors and actuators that it needs.
Power cable for an LMS111 or TIM551 type Sick laser scanner
Make your OpenCM9.04-A control board for Dynamixel servomotors complete with this accessory set.
10 cables (6cm lenght) with 4 pin connectors for the Dynamixel servomotors of the DX, RX and EX series.
Mechanical set for Dynamixel RX-24F, RX-28 and MX-28 actuators
The DMS-80 distance sensor offers to your Bioloid or Dynamixel mobile robots to measure distances and therefore to detect obstacles.