Dynamixel mounting plates, horns and bearing
You will find here the appropriate parts to tightly fix your Dynamixel actuators to the robot’s frame.
FP04-F12 frame for Bioloid kit. Compatible only with the AX-series Dynamixel servomotors. Bolts an nuts are not included (see the accessories section).
FP04-F17 wheel for the Robotis STEM kit. Compatible only with the AX-series Dynamixel servomotors and the OLLO motor and servo. Bolts, nuts (BNS-10) and tire (FP04-F18) are not included. Width: 18mm, diameter: 48mm
FP04-F18 wheel for the Robotis STEM kit. Compatible only with the AX-series Dynamixel servomotors and the OLLO motor and servo. the wheel (FP04-F17) is not included. Width: 18mm, diameter: 52mm
The FP04-F8 frames from Robotis are designed to adapt perfectly to the Dynamixel AX-series servo motors.
FP04-F12 frame for Bioloid kit. Compatible only with the AX-series Dynamixel servomotors. Bolts an nuts are not included (see the accessories section). This part can be used as a wheel when connected to a AX-12A servomotor.
FP04-F18 frame for Bioloid kit. Compatible only with the AX-series Dynamixel servomotors. Bolts an nuts are not included (see the accessories section).
In this set, you’ll find 10 sturdy plastic structural components for Dynamixel AX servo motors, suitable for replacing components in Bioloid robots.
This set of 10 FP04-F3 side mounting frames is designed for the Bioloid robotics kits by Robotis that use the AX series Dynamixel servomotors.
Horn for Dynamixel actuators RX-64 (N101 Type) ,EX-106+, MX-64 and MX-106
