Sanyo Pancake Stepper Motor: Bipolar, 200 Steps/Rev, 42×11.6mm, 3.5V, 1A/Phase
The Sanyo Pancake Stepper Motor is an ultra-flat (pancake-shaped) stepper motor distributed by Pololu.
Including €0.02 for ecotax
200 steps/rev, and a size compatible with all types of project
Standing just over 1 cm high, this pancake-shaped Sanyo stepper motor will fit into your smallest projects while developing a holding torque of 850 g.cm.
Simply connect it using its 4 coloured wires terminated with bare leads. The red and yellow wires connect to the positive and negative poles of a phase, and the orange and blue wires to the second coil. It can be controlled using two pairs of H-bridges or a bipolar stepper motor driver.
This type of stepper motor is ideal for projects involving a DIY 3D printer, linear actuator, hard drive and even a laser cutting system.
Technical specifications of the NEMA 17 Sanyo stepper motor
- Power: 2A per phase
- Voltage rating: 3.5V
- 200 steps per revolution
- Stepper angle: 1.8°
- Resistance: 3.5Ω per phase
- Holding torque: 850 g.cm
- Inductance: 1.2 mA per phase
- Shaft length: 30 cm
- Output shaft supported by two ball bearings
- Shaft diameter: 5 mm
- Dimensions: 42 x 42 x 11.6 mm (not including the shaft)
- Weight: 70 g