.

Arduino

Arduino is the perfect system for creating countless electronic circuits and for quick prototyping. Arduino is open-source, very easy to use, perfectly adapted for education, prototyping and designing simple or complex electronic and robotic projects (autonomous robots, IoT, smart systems...).

Active filters

This 6-Pin Stackable Header for Arduino will allow you to easily connect your compatible shields on an Arduino base.

In Stock

The instant 3-Pin SPDT Micro Switch offers 2 different connection possibilities, and can also switch to SPST mode.

In Stock

Black anodized heat sink for SMD circuit.

In Stock

These headers will allow you to stack several shields on top of your Arduino R3, Leonardo and new Arduino boards going forward.

In Stock

A holder for two lithium batteries with DC 2.1 jack connector and 7.4 V output voltage, to immediately power your Arduino project.

In Stock

This holder for 3 x 18650 batteries with jack plug is dedicated to Arduino users looking for a portable power supply.

In Stock

Use this simple compatible extension cable to equip your Arduino project with an on/off switch.

In Stock

Robust and very easy to install, this start/stop switch is a basic component that you should always have in stock.

In Stock

The MegaPi Shield for RJ25 has four RJ25 connection ports with Makeblock colour codes. This allows you to automatically connect the Makeblock Me electronic modules to your MegaPi, and to program your project with Arduino or using the Makeblock HD app.

In Stock

Transform your Arduino home project into a nomadic project with this 9V battery holder.

In Stock

This 5 x AA battery holder is the ideal choice for powering your projects on Arduino or any other compatible board.

In Stock

The 5 x 10 cm Heating Pad by SparkFun is an accessory that can be very easily connected and integrated into creations to help you get safely through the winter!

In Stock
€5.54

The TEM01052B Load Sensor is equipped with a flexible half-bridge allowing you to measure loads of up to 50 kg.

In Stock

Mechanical parts for easy Pan/Tilt setup

In Stock

This shield for Arduino enables you to incorporate the SparkFun Qwiic ecosystem to your programming board with no soldering required, so you can connect I2C sensors, actuators and shields the easy way!

In Stock

This little microSD USB reader is completely plug-and-play and features a USB interface for an immediate access to all data on your computer.

In Stock

The Pololu 12 Vdc 2-Channel SPDT Relay Carrier allows you to control 2 single pole, double throw switches (SPDT). It comes already assembled.

In Stock

This small voltage meter is ready to be embedded in your mobile robot to display the voltage you will put on its cables, for example the battery voltage.

In Stock

The Assembled Pi T-Cobbler Plus with GPIO Cable is the new Adafruit extension designed especially for Raspberry Pi B+ fans who want to be able to easily use all the additional ports offered by this board.

In Stock

The TCA9548A I2C multiplexer allows you to get up to 8 same-address I2C devices hooked up to one Arduino microcontroller.

In Stock

Compact and yet highly effective, the MAX98306 Stereo 3.7W Class D Audio Amplifier is the perfect device for your portable audio creations on Arduino!

In Stock
€9.70

Create all your Makeblock projects from an Arduino UNO with the Me UNO Shield!

In Stock

Version 2 of the base shield is a board allowing you to immediately connect all your Grove sensors and actuators to an Arduino board : no need for soldering or other risky DIY – everything is all ready to plug in!

In Stock

RobotGeek Sensor Shield V2 allows you to quickly connect a full range of sensors to your Arduino board, without getting tangled in cables!

In Stock