Active filters

This Arduino shield allows you to read and write NFC and RFID tags.

In Stock

Create new communication possibilities for your Arduino thanks to this CAN-BUS Shield, which can be plugged directly into your board for all your evaluation and prototyping projects!

In Stock

With the Uninterruptible Power Supply for Raspberry Pi, your board becomes safe and autonomous thanks to a rechargeable-battery system.

In Stock

What use would your RFID boards be without a matching module? This one is compatible with Arduino, Raspberry Pi and Intel Galileo [XBee Socket]. No more excuses for postponing your next IoT project!

DISCONTINUATED ARTICLE
€71.90

The GPRS Shield V2.0 module will give your Arduino project all the functionalities associated with the GPRS communication protocol – you’ll be able to send SMS messages and exchange data and voice communications with just a SIM card!

In Stock

The Arduino EVShield for EV3 is the easiest and most effective way of making your Lego EV3 or NXT creation even more interactive.

In Stock

Store lots of photos and Full HD+ videos using the SanDisk Extreme Pro 32 GB memory card, fast and highly resistant to day-to-day incidents.

In Stock

The Seeed Studio BLE Shield will allow you to incorporate the Bluetooth Low Energy technology into all your low-speed data transmission projects.

In Stock

In Stock

These headers will allow you to stack several shields on top of your Arduino R3, Leonardo and new Arduino boards going forward.

In Stock

The CAN-BUS shield V2 is making a name for itself as a must-have tool for all your hacking and electronic diagnosis operations. This version has been fully redesigned by Seeed Studio.

In Stock

The MicroView USB Programmer allows you to program your Arduino MicroView module (as its name suggests)!

In Stock

This shield for Arduino enables you to incorporate the SparkFun Qwiic ecosystem to your programming board with no soldering required, so you can connect I2C sensors, actuators and shields the easy way!

In Stock

Product available for orders

In Stock

The 16-Channel 12-Bit PWM/Servo Shield with I2C Interface makes even the most ambitious robotics projects possible with a bit of soldering!

In Stock

In Stock

In Stock

Robust and very easy to install, this start/stop switch is a basic component that you should always have in stock.

In Stock

In Stock

A holder for two lithium batteries with DC 2.1 jack connector and 7.4 V output voltage, to immediately power your Arduino project.

In Stock

Give all your Arduino projects a geolocation function with this Arduino MKR GPS Shield, equipped with a GNSS (Global Navigation Satellite System) receiver.

In Stock