Make your OpenCM9.04-A control board for Dynamixel servomotors complete with this accessory set.
The USB2AX is a small interface to control Dynamixel servomotors like the AX-12 or the MX-28T from a computer.
5 cables (15cm length) For 3P-5P conversion
10 cables (14cm lenght) with 4 pin connectors for the Dynamixel servomotors of the DX, RX and EX series.
10 cables (6cm lenght) with 4 pin connectors for the Dynamixel servomotors of the DX, RX and EX series.
10 cables (20cm lenght) with 4 pin connectors for the Dynamixel servomotors of the DX, RX and EX series.
use this PCB connector to extend your constructions based on Dynamixel actuators
10 cables (6cm lenght) with 3 pin connectors for the Dynamixel servomotors of the AX and MX-xxT series.
10 cables (18cm lenght) with 3 pin connectors for the Dynamixel servomotors of the AX and MX-xxT series.
10 cables (18cm lenght) with 4 pin connectors for the Dynamixel actuators of the MX (R version), RX and EX series.
Black frame to connect 2 Dynamixel EX-106+ or MX-106 in dual mode.
Frame to connect 2 Dynamixel EX-106+ or MX-106 in dual mode.
Horn and bearing set for Dynamixel actuators compatible with the RX-24F, RX-28 and MX-28 actuators.
Horn, black frame and bearing set for Dynamixel EX-106+ and MX-106 actuators
Horn, frame and bearing set for Dynamixel EX-106+ and MX-106 actuators
Frame for Dynamixel actuators EX-106+ and MX-106 to control then in dual mode (two synchronized Dynamixel actuators that are controlled simultaneously in a parallel to increase the torque).
Horn and Bearing set for Dynamixel compatible with RX-24F and RX-28 actuators.
Horn and bearing set for Dynamixel actuators compatible with the Dynamixel RX-64 (N101 type) and EX-106+.
Horn for Dynamixel actuators RX-64 (N101 Type) ,EX-106+, MX-64 and MX-106
Fixation frame set for the Dynamixel EX-106+ actuator