The Trossen Robotics 350 mm 3-pin cable is a go-to Dynamixel actuator project accessory.

This 3P Cable Set for Dynamixel servo motors in the AX and MX series lets you make all the standard connections between your robot and the various sensors and actuators that it needs.

Use this pack of five 3P-Sync 160 mm cables for connecting two Dynamixel MX-106 and X540 servos in master/slave mode.

These 4 x 120 mm 4P cables (for wireless module) are intended exclusively for connecting your Dynamixel servo motors using the RS485 protocol.

The 4P JST Expansion Board is an extension board that allows you to add additional features to your robot.

4 cables (400m length) with 5 pin connectors for some Dynamixel servomotors, sensors and controllers (CM-100, CM-150, CM-530, CM-700).

This pack of five 3P 110 mm Cables for XL Servos has been specially designed for connecting your Dynamixel servos to compatible controllers.

Choose quality cables for powering your Dynamixel XL servos tailored to your projects’ needs by opting for this pack of five 3P 130 mm Cables for XL Servos.

Choose quality cables for powering your Dynamixel XL servos tailored to your projects’ needs by opting for this pack of five 3P 160 mm Cables for XL Servos.

This heavy duty 3-pin ribbon cable is compatible with the Dynamixel AX and MX actuators.

This pack of four 5P cables (150 mm) from Robotis makes it easy to connect your robot sensors.

5 cables (15cm length) For 3P-5P conversion

Make your OpenCM9.04-A control board for Dynamixel servomotors complete with this accessory set.

ALF-M101 is a mounting plate compatible with the DYNAMIXEL aluminium profiles.

This kit includes 10 FP04-F1 type plastic components, compatible with Dynamixel servomotors of the AX-range.

The BNS-10 Nut and Bolt Set is a kit that will allow you to not only assemble Dynamixel AX (12+) servo motors, but also fit your mobile robot with an AX-S1 sensor and CM-5 or CM-510 controller.

The BNS-30 bolt/nut set for Dynamixel AX-series servos includes 70 tapping screws and can be used as an add-on to your BNS-10 set.

The BT-210 Bluetooth Module is a wireless communication module using Bluetooth technology: it allows your robot to connect with other devices fitted with a Bluetooth 2.1 interface.

When connected to a robot, this Robotis Bluetooth module allows a tablet or smartphone to control the robot using the Bluetooth Low Energy (BLE) 4.0 protocol.

The BT-410 set includes a master module and a slave module for transmitting data over a Bluetooth BLE connection, for instance between a robot and an RC-100B type wireless controller.

The BT-410 USB Bluetooth dongle enables you to establish communication between your robot and your PC via the BT-410 slave module.

The CM-150 Controller is used for programming robotics kits like the Robotis Dream Level 2. It will allow you to connect numerous components, for example sensors, gearmotors and LED modules.

The CM-530 main controller drives your Dynamixel servomotors AX and MX. It carries a ARM Cortex STM32F103RE microcontroller and is programmed in USB with the RoboPlus software.

This Dynamixel servo controller offers multiple functions for fully operating your robot in navigation mode. It includes various sensors and enough connection ports to add several devices.