Support set for RX-64, EX-106+, MX-64 and MX-106 Dynamixel servomotors
This EPX430-BR101 kit is an enhanced extension for the X430, offering optimum performance and even greater accuracy.
This gear set is designed to replace the gear parts on the X540 servo motors equipped with a reduction ratio of 270:1.
The Dynamixel HN13-N101 horn set is designed to adapt to the output shafts on Dynamixel XH-series and XM540 servos.
Use the M3x8 wrench bolts to fix your Dynamixel servos securely.
The Dynamixel FR12-H104K Frame Set includes all the screws and bolts needed to fix an articulated frame for a XH/XM430 or XL430 servo.
FP04-F12 frame for Bioloid kit. Compatible only with the AX-series Dynamixel servomotors. Bolts an nuts are not included (see the accessories section).
The Robotis Gear/Bearing Set for the MX-106 servo motor has been designed for the long-lasting replacement of your gear and bearing parts: robustness, endurance, and long life are the keywords here!
This Dynamixel servo controller offers multiple functions for fully operating your robot in navigation mode. It includes various sensors and enough connection ports to add several devices.
This pack of four 5P cables (150 mm) from Robotis makes it easy to connect your robot sensors.
The MGSS-10 magnetic sensor is a contact sensor... requiring no actual contact!
4 cables (400m length) with 5 pin connectors for some Dynamixel servomotors, sensors and controllers (CM-100, CM-150, CM-530, CM-700).
The CM-150 Controller is used for programming robotics kits like the Robotis Dream Level 2. It will allow you to connect numerous components, for example sensors, gearmotors and LED modules.
Black frame to connect 2 Dynamixel EX-106+ or MX-106 in dual mode.
Frame for Dynamixel actuators EX-106+ and MX-106 to control then in dual mode (two synchronized Dynamixel actuators that are controlled simultaneously in a parallel to increase the torque).
Horn and Bearing HN05-I1 for Dynamixel actuators
ALF-M101 is a mounting plate compatible with the DYNAMIXEL aluminium profiles.
This metal gear set is designed to last longer and resist abrasion. The gears are compatible with all servo motors in the Dynamixel X540-150 series with a TTL or RS-485 connection.
This structural component is designed specifically for the Dynamixel XW540, to fix your servo in the position that suits you best.
Use this structural component designed for the Dynamixel XW540 series to attach one side of a servo.
