10 cables (10cm lenght) with 3 pin connectors for the Dynamixel servomotors of the AX and MX-xxT series.
10 cables (14cm lenght) with 3 pin connectors for the Dynamixel servomotors of the AX and MX-xxT series.
Flexible and strong, these 240 mm X3P cables (x10) enable a fast connection between your Dynamixel X servos and their controller.
Dynamixel X-series compatible cable (TTL), length 50 cm.
This pack of five 3P 110 mm Cables for XL Servos has been specially designed for connecting your Dynamixel servos to compatible controllers.
10 cables (20cm lenght) with 4 pin connectors for the Dynamixel servomotors of the DX, RX and EX series.
Fixation frame for Dynamixel actuators compatible with RX-24F (N101 type), RX-28 (N101 type) and MX-28 smart actuators.
Mounting plate for Dynamixel actuators RX-64, EX-106+, MX-64 and MX-106
Add this 50 pieces S2 PHS Bolt M2*8 kit for Dynamixel servomotors to your roboticists’ toolbox.
You can use this set of structural components for Dynamixel XL330 servos to add a joint to your robotics project.
This set of Dynamixel structural components is the perfect fit for the new XM-430 Robotis motor!
This open-source controller would be the ideal choice for your TurtleBot3 robot; it is an ROS controller equipped with an ARM Cortex-M7 processor capable of accommodating your Dynamixel servos and many other modules!
The LBC-010 charger for LiPo battery allows to recharge the LBS-10 LiPo battery of the Premium Bioloid kit.
10 cables (6cm lenght) with 3 pin connectors for the Dynamixel servomotors of the AX and MX-xxT series.
35cm long cable for Dynamixel X-series servo motors, TTL protocol.
Get this gear set if the gears on your AX-18A Dynamixel servo are broken or worn out.
The Dynamixel communication bridge is designed to convert the RS485 or TTL signals from your servo motors into a single signal for analysis on your computer.
This complete idler bearing set for X540 series includes all the necessary mounting screws.
Have you ever been afraid of running out of assembly parts in the middle of a project? With this set of 400 S1 Bolt PHS M2x6 for Dynamixel Servomotors , you’ll have more than enough bolts to keep going for a while !
This kit includes 10 FP04-F1 type plastic components, compatible with Dynamixel servomotors of the AX-range.
Make your OpenCM9.04-A control board for Dynamixel servomotors complete with this accessory set.
Set with frame, horn and bearing for Dynamixel actuators