Pack of 6 Dynamixel AX-12A actuators (without any accessories)

With its impressive graphics architecture, powerful processor and multitude of hardware connections (audio, video, Ethernet, etc.), the NVIDIA Nano Development Kit is an affordable and feature-rich AI development solution for researchers, students and top-notch DIY enthusiasts.

To celebrate its 4th birthday, the Raspberry Pi Foundation is releasing the Raspberry Pi 3! It’s 50% more powerful than the previous version, but above all comes already equipped with WiFi and Bluetooth! It's also compatible with the Pi2 accessories.

The Lithium-Ion 3.7 V 1300 mAh LB-041 Battery is a rechargeable battery designed especially for your Robotis-Mini (*) robot and the OpenCM9.04 microcontroller.

Good news for all Raspberry Pi enthusiasts: the Raspberry Pi Zero WH board offers all the features of a Pi Zero, plus an already soldered GPIO 40-pin header!

The fastest actuator for positionning of the AX range

Horn and Bearing set for Dynamixel compatible with RX-24F and RX-28 actuators.

You can use this set of structural components for Dynamixel XL330 servos to add a joint to your robotics project.

This 1,800 mAh LIPO battery is the perfect choice for charging your TurtleBot 3, Robotis OP3 or DARwin-OP robot. It incorporates a PCM specially designed to protect the battery.

Horn and bearing set compatible with RX-64 (N101 type), EX-106+, MX-64 and MX-106 Dynamixel actuators.

The fastest actuator for positionning of the AX range

Looking for an efficient actuator in TTL mode? Discover the Dynamixel XM430-W350-T servo, a model of its kind in terms of performance and control!

Robotis has rounded out its XC330 range with some servo motors that are equally fast and fun to control. The Dynamixel XC330-T181-T servo will reach 113 rpm!

Manufacturer reference: 902-0170-000

A power adapter for the Pixl and Arduino boards, used to control the XL-320 servomotors and power up the Raspberry Pi that made up the Poppy Ergo Jr robot (or any other robot using these servos!)

This set of 10 FP04-F3 side mounting frames is designed for the Bioloid robotics kits by Robotis that use the AX series Dynamixel servomotors.

An essential accessory for your DARwin-Mini robot’s Li-Ion LB-041 Battery, the LBB-041 Battery Charger is very easy to assemble and use. It is compatible with the previous LB-040 battery.

Discover the Dynamixel XM430-W210-T servo, offering versatility, full control, a high transmission rate and a TTL interface.

The MX-28AT is an improvement upon the MX-28T model. "A" stands for "Aluminium", the new aluminium body is now allowing a better heat distribution, and the MX-28AT is also equipped with a new fastening system.

The HN12-I101 Horn Set is the perfect fit for Dynamixel X-series 430 servos.

The OpenCM 485 Expansion Board connects to your OpenCM9.04 Controller so you can benefit from additional Dynamixel ports.

Do you need to make an addition to your TurtleBot3? You’ll never get caught out with the IPL-01 plate for TurtleBot Waffle!

Dynamixel X-series compatible cable (TTL), length 50 cm.

The OpenRB-150 is a next-generation, open-source, Arduino compatible embedded controller.

The BNS-10 Nut and Bolt Set is a kit that will allow you to not only assemble Dynamixel AX (12+) servo motors, but also fit your mobile robot with an AX-S1 sensor and CM-5 or CM-510 controller.