The Dynamixel shield for Arduino from Robotis can be used to control yourDynamixel servo motors using your Arduino board or an OpenCR controller.
When connected to a robot, this Robotis Bluetooth module allows a tablet or smartphone to control the robot using the Bluetooth Low Energy (BLE) 4.0 protocol.
10 x 24cm cables with 4 pin connectors for Dynamixel DX, RX and EX series servomotors
This pack of medium-length X4P cables for Dynamixel XM-430 offers greater flexibility in terms of wiring.
The Dynamixel HN13-N101 horn set is designed to adapt to the output shafts on Dynamixel XH-series and XM540 servos.
The HNX430-C101 set consists of a clamping horn and a complete set of screws to adapt to an XH430 or XM430 actuator.
10 cables (20cm lenght) with 4 pin connectors for the Dynamixel servomotors of the DX, RX and EX series.
The X4P 100 mm cable is designed especially for connecting your Dynamixel XM-430 servos quickly and efficiently. You’ll find it hard to do without this Robotis cable!
10 cables (18cm lenght) with 4 pin connectors for the Dynamixel actuators of the MX (R version), RX and EX series.
The U2D2 board from Robotis enables you to supply a variety of power sources to your Dynamixel servo motors.
The new Dynamixel servo has arrived, and Robotis has developed a whole series of structural component sets so you can mount your XM-430 without mishap. The FR12-S102K set is one of them.
This pack of ten 180 mm X4P cables (convertible) is to be used with Dynamixel X-series servo motors with an RS485 interface.
Pack of 10 TTL communication cables for the Dynamixel X-series servomotors.
The LBC-010 charger for LiPo battery allows to recharge the LBS-10 LiPo battery of the Premium Bioloid kit.
10 cables (14cm lenght) with 4 pin connectors for the Dynamixel servomotors of the DX, RX and EX series.
Horn and bearing set compatible with RX-64 (N101 type), EX-106+, MX-64 and MX-106 Dynamixel actuators.
The HN12-I101 Horn Set is the perfect fit for Dynamixel X-series 430 servos.
Mounting plate for Dynamixel actuators RX-64, EX-106+, MX-64 and MX-106
Mounting plate for Dynamixel smart actuators that is compatible with RX-64, EX-106+, MX-64 et MX-106 actuators.
The DMS-80 distance sensor offers to your Bioloid or Dynamixel mobile robots to measure distances and therefore to detect obstacles.
Choose quality cables for powering your Dynamixel XL servos tailored to your projects’ needs by opting for this pack of five 3P 160 mm Cables for XL Servos.