The USB2AX is a small interface to control Dynamixel servomotors like the AX-12 or the MX-28T from a computer.
10 cables (14cm lenght) with 3 pin connectors for the Dynamixel servomotors of the AX and MX-xxT series.
Support set for RX-64, EX-106+, MX-64 and MX-106 Dynamixel servomotors
The DYD-15-051 high-precision gear is a cycloid-based reducer designed to offer optimum strength and robustness throughout its 5,000 hours of use.
The U2D2 board from Robotis enables you to supply a variety of power sources to your Dynamixel servo motors.
Properly fix your Dynamixel servomotors with this set of 200 M2.5x8 wrench bolts. An essential item for your toolkit!
10 cables (18cm lenght) with 3 pin connectors for the Dynamixel servomotors of the AX and MX-xxT series.
Horn and Bearing HN05-I1 for Dynamixel actuators
The CM-530 main controller drives your Dynamixel servomotors AX and MX. It carries a ARM Cortex STM32F103RE microcontroller and is programmed in USB with the RoboPlus software.
Bundle of all accessories required to configure and supply power to your Dynamixel servomotors.
Have you ever been afraid of running out of assembly parts in the middle of a project? With this set of 400 S1 Bolt PHS M2x6 for Dynamixel Servomotors , you’ll have more than enough bolts to keep going for a while !
The Robotis Gear/Bearing Set for the MX-106 servo motor has been designed for the long-lasting replacement of your gear and bearing parts: robustness, endurance, and long life are the keywords here!
use this PCB connector to extend your constructions based on Dynamixel actuators
Horn and bearing set compatible with RX-64 (N101 type), EX-106+, MX-64 and MX-106 Dynamixel actuators.
10 cables (20cm length) with 3 pin connectors for the Dynamixel servomotors of the AX and MX-xxT series.
You can now power, connect and program all your Dynamixel servos, whatever the model, thanks to this official and very clever Dynamixel starter set.
The BNS-10 Nut and Bolt Set is a kit that will allow you to not only assemble Dynamixel AX (12+) servo motors, but also fit your mobile robot with an AX-S1 sensor and CM-5 or CM-510 controller.
The 903-0205-000 gear/bearing set is the replacement kit to choose if you want to give your Dynamixel MX-64 servo motor a new lease of life.
Kit containing horn, frame and bearing for Dynamixel actuators
Need a remote to control your Robotis robotics kit? The RC-100B Remote Control offers you up to 1,023 different command combinations and 3 different communication protocols!
10 cables (10cm length) with 4 pin connectors for the Dynamixel actuators of the MX (R version), RX and EX series.